On 09/01/2010 04:39 PM, aragonx@xxxxxxxxxx wrote: > Hello all, > > I am running fedora 12 and have two bonded interfaces. Everything > works fine if I manually start my bonded interface (bond0). It also > works fine if I put (ifup bond0) in /etc/rc.d/rc.local. However, it > refuses to start on boot otherwise and rc.local is kinda late in the > boot sequence. Things that require the network to be running become > very unhappy. > > NM is not running so that can not be interfering. I have three > systems all using Intel NICs but otherwise different hardware. They > are all having this issue. What am I missing (ID 10 T error > probably)? As always, any help would be appreciated. > > Here is some system information: > > # chkconfig|grep Network > NetworkManager 0:off 1:off 2:off 3:off 4:off 5:off 6:off > > # uname -a > Linux test 2.6.32.19-163.fc12.x86_64 #1 SMP Wed Aug 18 11:38:54 UTC > 2010 x86_64 x86_64 x86_64 GNU/Linux > > # cat /etc/modprobe.conf > alias bond0 bonding > options bond0 miimon=100 mode=4 > > # cat ifcfg-bond0 > DEVICE=bond0 > IPADDR=10.64.236.67 > NETMASK=255.255.255.0 > NETWORK=10.64.236.0 > BROADCAST=10.64.236.255 > ONBOOT=yes > BOOTPROTO=none > USERCTL=no > BONDING_OPTS="miimon=100 mode=4" > NM_CONTROLLED=no > GATEWAY=10.64.236.1 > TYPE=Ethernet > IPV6INIT=no > NAME="system bond0" > IPV4_FAILURE_FATAL=yes > > # cat ifcfg-eth0 > # Intel Corporation 82546EB Gigabit Ethernet Controller (Copper) > DEVICE=eth0 > USERCTL=no > ONBOOT=yes > MASTER=bond0 > SLAVE=yes > BOOTPROTO=none > HWADDR=00:14:4F:78:4D:64 > TYPE=Ethernet > NM_CONTROLLED=no > IPV6INIT=no > NAME="system eth0" > UUID=5fb06bd0-0bb0-7ffb-45f1-d6edd65f3e03 > > # cat ifcfg-eth1 > # Intel Corporation 82546EB Gigabit Ethernet Controller (Copper) > DEVICE=eth1 > USERCTL=no > ONBOOT=yes > MASTER=bond0 > SLAVE=yes > BOOTPROTO=none > HWADDR=00:14:4F:78:4D:65 > NM_CONTROLLED=no > TYPE=Ethernet > IPV6INIT=no > NAME="system eth1" > > > # ifconfig > bond0 Link encap:Ethernet HWaddr 00:14:4F:78:4D:64 > inet addr:10.64.236.67 Bcast:10.64.236.255 Mask:255.255.255.0 > inet6 addr: fe80::214:4fff:fe78:4d64/64 Scope:Link > UP BROADCAST RUNNING MASTER MULTICAST MTU:1500 Metric:1 > RX packets:1097 errors:0 dropped:0 overruns:0 frame:0 > TX packets:658 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:0 > RX bytes:141477 (138.1 KiB) TX bytes:137257 (134.0 KiB) > > eth0 Link encap:Ethernet HWaddr 00:14:4F:78:4D:64 > UP BROADCAST RUNNING SLAVE MULTICAST MTU:1500 Metric:1 > RX packets:582 errors:0 dropped:0 overruns:0 frame:0 > TX packets:271 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:1000 > RX bytes:77525 (75.7 KiB) TX bytes:56514 (55.1 KiB) > > eth1 Link encap:Ethernet HWaddr 00:14:4F:78:4D:64 > UP BROADCAST RUNNING SLAVE MULTICAST MTU:1500 Metric:1 > RX packets:516 errors:0 dropped:0 overruns:0 frame:0 > TX packets:388 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:1000 > RX bytes:64012 (62.5 KiB) TX bytes:80977 (79.0 KiB) > > --- > Will Y. > -- > This message has been scanned for viruses and > dangerous content by *MailScanner* <http://www.mailscanner.info/>, and is > believed to be clean. Here is sample from a system here. Looks very close to yours. We have never had a problem with them coming up ... [root@kvm1 network-scripts]# cat *bond0 DEVICE=bond0 IPADDR=172.20.17.1 NETMASK=255.255.240.0 MTU=9000 ONBOOT=yes BOOTPROTO=none USERCTL=no BONDING_MASTER="yes" BONDING_MODULE_OPTS="mode=802.3ad miimon=100" BONDING_SLAVE0="eth2" BONDING_SLAVE1="eth3" [root@kvm1 network-scripts]# cat *eth2 DEVICE=eth2 USERCTL=no ONBOOT=yes MASTER=bond0 SLAVE=yes BOOTPROTO=none MTU=9000 [root@kvm1 network-scripts]# cat *eth3 DEVICE=eth3 USERCTL=no ONBOOT=yes MASTER=bond0 SLAVE=yes BOOTPROTO=none MTU=9000 -- users mailing list users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe or change subscription options: https://admin.fedoraproject.org/mailman/listinfo/users Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
