Zoltan Hoppar <hopparz <at> gmail.com> writes: > ... > Still shows no wifi network, just "disconnected" at NM. > But the driver is in: > (lspci -vnn)06:00.0 Network controller [0280]: Broadcom Corporation BCM4312 > 802.11b/g LP-PHY [14e4:4315] (rev 01) > > Subsystem: Hewlett-Packard Company Device [103c:1508] Physical Slot: 1 > Flags: bus master, fast devsel, latency 0, IRQ 17 Memory at 92000000 > (64-bit, non-prefetchable) [size=16K] Capabilities: <access denied> > > Kernel driver in use: wl > Kernel modules: wl, ssb > The problem is doesn't see the ESSID's, just "disconnected". > Or simply just doesnt support this driver? > ... Hi, Check your BIOS for anything related. FAQ: http://wireless.kernel.org/en/users/Drivers/b43/faq Have you examined your dmesg, /var/log/messages carefully ? These are the devs of b43 firmware. $ yum info b43-openfwwf http://www.ing.unibs.it/openfwwf/ If you need help, send a message to the OpenFWWF team at openfwwf@xxxxxxxxxxxx ... To make firmware work properly: $ cat /etc/modprobe.d/openfwwf.conf options b43 nohwcrypt=1 qos=0 You can retry: # modprobe -r b43 # modprobe b43 nohwcrypt=1 qos=0 and check /var/log/messages. # modinfo b43 # lsmod |grep -i b43 Btw, please do not top post (on top of previous text) - most people prefer bottom posting, otherwise some can get angry and refuse helping you :-) JB -- users mailing list users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe or change subscription options: https://admin.fedoraproject.org/mailman/listinfo/users Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
