On 05/03/2010 07:08 PM, Tom Horsley wrote: > On Mon, 03 May 2010 18:57:23 -0400 > Jim wrote: > > >> Whereis Virt Manager ? >> I look for it but could not find. >> > I's /usr/bin/virt-manager on my system, perhaps you don't > have the entire virtualization program group installed? > > Also, the name virbr0 may be out of date. I just looked > on my system, (where I currently have 2 virtual machines > running on the bridge interface), and I see this from > ifconfig: > > br0 Link encap:Ethernet HWaddr 00:1B:21:3A:00:F3 > inet addr:192.168.1.106 Bcast:192.168.1.255 Mask:255.255.255.0 > inet6 addr: fe80::21b:21ff:fe3a:f3/64 Scope:Link > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > RX packets:10350246 errors:0 dropped:0 overruns:0 frame:0 > TX packets:8895237 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:0 > RX bytes:7419469965 (6.9 GiB) TX bytes:1851025477 (1.7 GiB) > > eth0 Link encap:Ethernet HWaddr 00:1B:21:3A:00:F3 > inet6 addr: fe80::21b:21ff:fe3a:f3/64 Scope:Link > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > RX packets:10365591 errors:0 dropped:0 overruns:0 frame:0 > TX packets:8930748 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:1000 > RX bytes:7587557604 (7.0 GiB) TX bytes:1853458690 (1.7 GiB) > Memory:febe0000-fec00000 > > lo Link encap:Local Loopback > inet addr:127.0.0.1 Mask:255.0.0.0 > inet6 addr: ::1/128 Scope:Host > UP LOOPBACK RUNNING MTU:16436 Metric:1 > RX packets:310941 errors:0 dropped:0 overruns:0 frame:0 > TX packets:310941 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:0 > RX bytes:50996677 (48.6 MiB) TX bytes:50996677 (48.6 MiB) > > vnet0 Link encap:Ethernet HWaddr 1A:7E:39:6E:3E:37 > inet6 addr: fe80::187e:39ff:fe6e:3e37/64 Scope:Link > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > RX packets:4503 errors:0 dropped:0 overruns:0 frame:0 > TX packets:13775 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:500 > RX bytes:314051 (306.6 KiB) TX bytes:11986953 (11.4 MiB) > > vnet1 Link encap:Ethernet HWaddr CA:21:C0:18:AC:82 > inet6 addr: fe80::c821:c0ff:fe18:ac82/64 Scope:Link > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > RX packets:4410 errors:0 dropped:0 overruns:0 frame:0 > TX packets:11904 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:500 > RX bytes:310520 (303.2 KiB) TX bytes:11861044 (11.3 MiB) > > The br0 interface is my bridge setup by this ifcfg-br0 file: > > # Networking Interface > DEVICE=br0 > TYPE=Bridge > BOOTPROTO=static > GATEWAY=192.168.1.1 > IPADDR=192.168.1.106 > IPV6INIT=no > NETMASK=255.255.255.0 > ONBOOT=yes > PEERDNS=no > USERCTL=no > NM_CONTROLLED=no > > The eth0 interface is attached to the bridge: > > # Please read /usr/share/doc/initscripts-*/sysconfig.txt > # for the documentation of these parameters. > DEVICE=eth0 > #BOOTPROTO=none > #GATEWAY=192.168.1.1 > HWADDR=00:1b:21:3a:00:f3 > #IPADDR=192.168.1.106 > #NETMASK=255.255.255.0 > ONBOOT=yes > TYPE=Ethernet > IPV6INIT=no > USERCTL=no > BRIDGE=br0 > NM_CONTROLLED=no > PEERDNS=no > > And the vnet0 and vnet1 interfaces were created by > libvirtd to run my virtual machines on the bridge. > Thanks for your help. It is bewildering to get info about Fedora off the Internet tomorrow it's out of date. Thanks again. -- users mailing list users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe or change subscription options: https://admin.fedoraproject.org/mailman/listinfo/users Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
