|
When I learned about ip address, the network & host portions of the
IP and the netmask to differentiate the host & network numbers. I learned a class A addr used a mask of 10.255.255.255. My current domain pre-existed my arrival. While my FC11 works fine, I was looking at this network config and found the below!!! eth0 Link encap:Ethernet HWaddr 00:26:18:FE:75:91 inet addr:10.0.0.100 Bcast:11.255.255.255 Mask:254.0.0.0 inet6 addr: fe80::226:18ff:fefe:7591/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:8291136 errors:0 dropped:0 overruns:0 frame:0 TX packets:8464483 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:8084873362 (7.5 GiB) TX bytes:8107599565 (7.5 GiB) Interrupt:35 cat ./devices/ifcfg-eth0 # Networking Interface DEVICE=eth0 BOOTPROTO=static DNS1=10.0.0.199 GATEWAY=10.0.0.129 HWADDR=00:26:18:FE:75:91 IPADDR=10.0.0.100 NETMASK=10.0.0.255 > My question, if the ifcfg-eth0 has the right IP & Mask, why does the ifconfig display not agree? More, why does it work as is ???!!! tia, jackc... -- Jack Craig Software Engineer 831.461.7100 x120 www.extraview.com |
-- users mailing list users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe or change subscription options: https://admin.fedoraproject.org/mailman/listinfo/users Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
