>Brian Wood wrote:
>> I'm having some trouble getting internet/ssh working over
>> a Linksys wireless usb adapter -- model WUSB54GSC.
>>
>> I did get it working one time, but don't know why or if
>> I did something to make it work. I see the access
>> point I want to use and connect to it. That seems to work.
>> Then iwconfig reports
>>
>> lo no wireless extensions.
>>
>> eth0 no wireless extensions.
>>
>> wlan2 IEEE 802.11bg ESSID:"brian"
>> Mode:Managed Frequency:2.432 GHz Access Point: 00:1C:10:3B:06:97
>> Bit Rate=36 Mb/s Tx-Power=14 dBm
>> RTS thr=2347 B Fragment thr=2346 B
>> Link Quality=57/100 Signal level=57/100
>> Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
>> Tx excessive retries:0 Invalid misc:0 Missed beacon:0
>>
>> But bringing up a URL or ssh'ing to another machine doesn't work.
>> I'm using Fedora 12. If I use an ethernet cable instead of the
>> wireless, everything works fine. Any ideas on what to check
>> or do?
>>
> I see two things here, one is that there is no IP on that wlan2, indicating that
> it is connected but not routed. The other is that it's wlan2 insteadl of wlan0,
> indicating that something is going on, since even with the built-in (802.11g)
> and plug-in (802.11n) NICs, I have wlan0 and wlan1, so they always do start and
> zero and go consecutively.
>
> Try:
> - dhclient wlan2
> - netstat -r
> and post the results. I would expect you will get connections after that.
Hi, Bill,
Unfortunately I've not been able to get it working yet. dhclient
didn't output anything. The netstat -r output:
Kernel IP routing table
Destination Gateway Genmask Flags MSS Window irtt Iface
192.168.50.0 * 255.255.255.0 U 0 0 0 wlan2
default 192.168.50.1 0.0.0.0 UG 0 0 0 wlan2
> Your dmesg output should have information of why that's wlan2, please read and
> report.
Here's the result of dmesg | grep wlan:
wlan0: register 'rndis_wlan' at usb-0000:00:03.3-1, Wireless RNDIS device, BCM4320b based, 00:1e:e5:a6:98:ee
usbcore: registered new interface driver rndis_wlan
udev: renamed network interface wlan0 to wlan2
rndis_wlan 1-1:1.0: rndis media disconnect
ADDRCONF(NETDEV_UP): wlan2: link is not ready
rndis_wlan 1-1:1.0: rndis media connect
ADDRCONF(NETDEV_CHANGE): wlan2: link becomes ready
wlan2: no IPv6 routers present
rndis_wlan 1-1:1.0: rndis media disconnect
rndis_wlan 1-1:1.0: rndis media connect
rndis_wlan 1-1:1.0: rndis media disconnect
rndis_wlan 1-1:1.0: rndis media connect
Regards,
Brian Wood
http://www.webEbenezer.net
-- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines
