On Sun, Nov 08, 2009 at 05:14:39PM -0500, Dennis Mattingly wrote: > Do I have to use static-IP address to reach router? > I'm still using DHCP. > ... > So my last questions would be: > "Am I required to use Static IP address just to configure a router (via IP > address)"? > "Do I need any gateway settings / subnet / etc... just to access the > router's IP address?" IF the router is set up with DHCP, you *should* get an IP address. Under Windows, from a command prompt run the command "ipconfig /all". Under Linux, run the CLI command "ifconfig". In either case, look for your IP address, and the gateway IP address. If both are set, try to run a browser connecting to the gateway. However, if DHCP has been disabled, or something strange is going on, yes, you want a static address. Most routers are either in the 192.168.1.0 or 192.168.0.0, with some (notably WatchGuard) different, e.g., 192.168.111.0. Look up your router either at the manufacturer's site, or on the Internet. If you can't find the doccos, try the followin static address configurations: IP Netmask Gateway 192.168.1.100 255.255.255.0 192.168.1.1 192.168.1.100 255.255.255.0 192.168.1.254 192.168.0.100 255.255.255.0 192.168.0.1 192.168.0.100 255.255.255.0 192.168.0.254 DNS typically won't matter for this. For each, try connecting to the gateway address with your browser. Cheers, -- Dave Ihnat dihnat@xxxxxxxxxx -- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines
