Re: duplex prob

[sureshbabu ct <sureshbabuvly@xxxxxxxxx>]

ethtool result..........


 ethtool eth0
Settings for eth0:
        Supported ports: [ TP MII ]
        Supported link modes:   10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
        Supports auto-negotiation: Yes
        Advertised link modes:  Not reported
        Advertised auto-negotiation: No
        Speed: 10Mb/s
        Duplex: Half
        Port: MII
        PHYAD: 32
        Transceiver: internal
        Auto-negotiation: off
        Current message level: 0x00000000 (0)
        Link detected: no

2009/9/12 Jorge Fábregas <jorge.fabregas@xxxxxxxxx>

On Saturday 12 September 2009 02:01:33 pm sureshbabu ct wrote:
> eth0: 10 Mbit, half duplex, no link

If I remember well..even if the interface drops to half-duplex, you shouldn't
see "no link" on the mii-tool output.  Does "ethtool eth0" show no link as
well?  Did you check the LED on the card? Is the port on the switch
configured auto or manually? That's what I would do...

HTH,
Jorge

--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines

-- 

         (¨`·.·´¨)    with
          `·.¸(¨`·.·´¨)    Luv
         (¨`·.·´¨)¸.·´   Suresh Vellinezhi.
          `·.¸.·´
-- 
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines