> 15. Re: F10 Update errors (stan) > On Fri, 04 Sep 2009 18:08:36 -0400 > vincent Onelli <vonelli@xxxxxxxxxxxxx> wrote: > > > For a period of time now every time there is an automatic update it is > > stopped because error, the following is the error info what I was able > > to get. > ... > > For while I am using "yum clean metadata ; yum update" > > some time even here I get some line with error > > I am using HP zv6000 dual boot 1 Gb of memory, IDE hard disk 40 GB > > partition > > if any body has the answer I will appreciate very much and thank you > > in advance. Vinny > > > > I don't know if I have an answer, but I have some suggestions. > > Edit /etc/yum.conf and change debuglevel=2 to debuglevel=6 or 10 so > you see more error messages. > > Edit /etc/yum/pluginconf.d/refresh-packagekit.conf and turn it off. The > first set of errors seem to be occurring in that component. This is > because it is trying to access an empty list (that seems to be a bug as > it should have protection against that). This might just be a symptom, > and there could be nothing wrong with this plugin. This removes a > complicating factor from the problem. > > The second set of errors is the same, the main yum process is trying to > access an empty list. Maybe your rpm db is corrupted. Try running rpm > --rebuilddb and when it completes try the yum command again. > > Run yum-complete-transaction. > > Run package-cleanup --problems > > No guarantees, but these might help you get closer to diagnosing the > problem. > rpm --rebuiltdb did not run yum-complete-transaction and package-cleanup --problems they both ran for quite while in the end I lost couple programs "PCB" and "open office" and the menu selection "add/remove software" that I could see, no problem apparently it fix also what was wrong it allow me to complete the f11 installation. I had an automatic f11 upgrade that never ran the full installation, in the past every time I selected the f11 on boot hung up, this time it did it went through the full installation without any problem. PCB I reinstalled by using yum, the add/remove software I do not know how to do it or if there is way. I will appreciate a hint, and thank you for the help Vinny -- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines
