Just did a fresh install of F11 on a P4. The SATA hard disk was repatriated from a broken iMac. I didn't have install disks handy, so I downloaded the netinstall image and installed the whole thing over my home DSL. This took nearly a day and a half, and I don't want to repeat that process if I can avoid it. I instructed anaconda to remove everything and use the whole drive. The installer never complained of any trouble. When I went to reboot, the system refused to recognize the hard drive as bootable. I jacked around with BIOS settings to no avail. Finally, I booted from the install CD and selected rescue mode. Rescue mode mounted /dev/sda2 on /mnt/sysimage. I looked and the install appears intact. I ran fdisk on /dev/sda and it complained, "Device contains neither a valid DOS partition table, nor Sun, SGI or OSF disklabel." And then further down, "Warning: invalid flag 0x0000 of partition table 4 will be corrected by w(rite)." There are no partitions listed when I select "p" to do so. At this point, I'm petrified. What can be done to fix this and get Fedora to boot? -Alan -- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines
