> Mike Burger wrote: >>> I am still struggling with this f10 install. It appeared that the >>> NIC in eth0 was no good. I pulled it out and left the second card >>> which was/is eth1. >>> >>> It looks to me like that designation eth1 might be changed to eth0 >>> using ethtool but if so, I can't find the right command. >>> >>> I have used service-config-network to set it up as 192.168.1.10 and >>> eth1, network-scripts is set up for eth1. but no matter what I do a >>> ping to another computer yields "Network is unreachable." >>> >>> This is a wired connection. I've tried a different cat5 cable. >>> "ethtools eth1" looks ok compared to the other computers. Not sure >>> what I have missed but it would be simpler perhaps if I could >>> convince the NIC that it was eth0 instead of eth1 but I can't >>> determine how that is set. >>> >>> Any help appreciated. I am about at wits end. >>> >> >> Actually, it's probably in your /etc/modprobe.conf file. >> >> >> > > /etc/modprobe.conf is an empty file? > Do I need to use it to change the eth designation? Don't know how > but ... Used to...it's possible that it's being done via udev, at this point. Lemme look around at ethtool and udev info. -- Mike Burger http://www.bubbanfriends.org Visit the Dog Pound II BBS telnet://dogpound2.citadel.org or http://dogpound2.citadel.org To be notified of updates to the web site, visit: https://www.bubbanfriends.org/mailman/listinfo/site-update or send a blank email message to: site-update-subscribe@xxxxxxxxxxxxxxxxx -- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines
