On Thu, Feb 5, 2009 at 1:52 PM, Rick Bilonick <rab@xxxxxxxxxxxx> wrote: > I installed F10 64-bit on a Dell quad computer without any problems. > (The computer had been running F5.) I did a fresh install on a new hard > drive. eth0 worked fine under F5. I can get a connection using ssh and > IP addresses but I cannot get DNS to work, even though I'm using the > same DNS addresses (which I can ping). When I use the gui and put in the > netmask (255.255.255.0), the gui constantly overwrites it. To get any > connection, I have to go into the eth0 config file and set the netmask. > (The gui always replaces the netmask IP with either the computer's IP or > gateway IP - don't remember which.) I can't get this working so I can do > an update. > > Any idea on what is going wrong? > > Rick B. > > -- > fedora-list mailing list > fedora-list@xxxxxxxxxx > To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list > Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines > WARNING: this action overwrites /etc/resolv.conf. In the ifcfg-eth0 put a line with the DNS info DNS1=xxxx.xxxx.xxxx.xxxx Then do 'service network restart' --this will put the DNS info into the /etc/resolv.conf. Works form me in F10. As an aside... I'm not running running NetworkManager. ~af -- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines
