iarly selbir wrote:
run the command lspci and see if the "atheros" appears on the output
Example, my lspci:
0c:00.0 Ethernet controller: Atheros Communications Inc. AR242x
802.11abg Wireless PCI Express Adapter (rev 01)
It does.
03:04.0 Ethernet controller: Atheros Communications Inc. AR5413
802.11abg NIC (rev 01)
Subsystem: Atheros Communications Inc. EnGenius EMP-8602 (400mw)
or Compex WLM54AG (SuperAG)
Flags: bus master, medium devsel, latency 168, IRQ 17
Memory at c2100000 (32-bit, non-prefetchable) [size=64K]
Capabilities: [44] Power Management version 2
Kernel driver in use: ath5k_pci
Kernel modules: ath5k
Now what? How do I define the interface so I can bring it up? And so
NetworkManager will recognize it?
Regards,
---------------------------------------------
iarly Selbir ( Ski0s )
On Wed, Dec 3, 2008 at 8:42 PM, Robert Moskowitz <rgm@xxxxxxxxxxxxxxx
<mailto:rgm@xxxxxxxxxxxxxxx>> wrote:
When I do an ifconfig I only see eth0 and lo.
system-config-network only shows eth0
I know the Atheros card is there...
--
fedora-list mailing list
fedora-list@xxxxxxxxxx <mailto:fedora-list@xxxxxxxxxx>
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
Guidelines:
http://fedoraproject.org/wiki/Communicate/MailingListGuidelines
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines
