Hi, I am among the one of first to grab the Fedora 10 release. Just installed the fresh copy from i386-DVD and installation went smooth. After reboot, I tried to set my network card from DHCP to static IP through Gnome Network Administration tool and everything became a mess plus my network stopped working. It seems like the graphical network configuration tools still have problem. These are the problem I found. =================================== 1) In graphical network configuration - when you set the IP Address, Subnet mask and gateway, save the changes. When I went back, my subnet mask was replaced with my gateway address. 2) network daemon was initially disabled in the services, which I found out and set to run in run levels 3 and 5. 3) DNS addresses set were not there in /etc/resolv.conf file. It was blank. =================================== To solve the problem I did following in command line: ============================= 1) set the Network Manager off 2) made changes in "/etc/sysconfig/networking/devices/ifcfg-eth0" as follows: a) ONBOOT=no (previous setting) changed to ONBOOT=yes b) NETMASK=192.168.1.1 and GATEWAY=192.168.1.1 (previously), changed NETMASK to right setting 255.255.255.0 3) set the DNS entry by hand in /etc/resovl.conf file ============================== Now it is working. By the way I didn't see the network card configuration during setup process which I used to see in previous Fedora installaions. I skipped Fedora 9. Are you experiencing also the same (similar) problems in Fedora 10? or I am the only one? Please confirm. Thanks -- ======================= Registered Linux User #460714 Currently Using FC8 ======================= -- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines
