On Fri, 2008-11-07 at 11:15 -0500, Todd Denniston wrote: > Jeff Maxwell wrote, On 11/07/2008 10:51 AM: > > This is great information. I do not know if my question fits this > > thread or not, but, > It would probably be best to start another thread, with a fully new (not reply > to this one) message. > > > I have an issue where I have been able to install > > and access an HP parallel OfficeJet printer via the "root" sign on but I > > am not able to access the printer via a local user sign on. Any > > suggestions would be much appreciated. > > take a look in /var/log/cups/ at page_log, error_log and access_log and see if > there is something that make sense there, before starting your new thread. > > If there is no info there, then you may have to (backup first and) edit > /etc/cups/cupsd.conf to set LogLevel to debug instead of info, then `service > restart cups`. (hopefully a restorecon /etc/cups/cupsd.conf will not be needed) > try a few prints and check the logs again. Thanks for the advice. I've been busy with other issues and finally found time to look further into this. I did find the following in the cupsd.conf and I am wondering if the SystemGroup is causing my problem as I appear to be able to access my printer/scanner when logged in as "root" but not as a local user. MaxLogSize 0 LogLevel info SystemGroup sys root Thoughts? > > -- > Todd Denniston > Crane Division, Naval Surface Warfare Center (NSWC Crane) > Harnessing the Power of Technology for the Warfighter > -- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines
