I had downloaded and burned another DVD, which I thought I would try. I put it into a machine which dual-boots, either to one hard drive with F8 or rarely to the other, which has XP. I ran the test on the disk, and all seemed well. The install began, and then suddenly the whole screen went white, and stayed that way. When at last I tried to goose it, it wouldn't react to anything, not even the power switch held down. I finally pulled the plug. It still boots to XP all right. It offers to boot to F8, the default, but I didn't check that; maybe I should. So I put in the DVD from which I had successfully gotten F9 onto three machines, and told XP to reboot. It has done the same thing -- gone through the first few steps, only to sit there with a blank white screen. The monitor is new, a HP w2207h 1680x1050; but the other two PCs manage with it, both behind a KVM switch and directly connected. And the dual-boot machine is much the newest! What could be doing this, and how do I fix it?? -- Beartooth Staffwright, Not Quite Clueless Power User C5; D4; F8; P3; U7.10; Alpine 1.10, Pan 0.132; Privoxy 3 Remember I know little (precious little!) of where up is. -- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
