On Fri, 2008-04-11 at 12:29 -0400, Claude Jones wrote: > The problem: > Company has switched over to FIOS and I have to move behind a > router > I will be behind a 10.0.0.1 LAN on a Cisco Router > I will be configured with an outside address, let's say > 70.xxx.xxx.120 for argument's sake > Traffic to that address from the outside will be routed to my box > inside the network by the Cisco > I need to tell the box/outside NIC that its gateway is 10.0.0.1 > even though it's not an address within the IP/subnet that the > NIC is configured for > > There are reasons for this > Before you say it can't be done, google my subject line and > you'll find this nice howto for Debian > http://siddhesh.in/foreign-gateway.php > I'm wondering if I need to pursue the route in that howto, or > whether I can configure this with the system-config-network GUI > in Fedora -- I see there's a 'Route' tab in there, but I've > never used it As that article intimates, this is poor design, though the author obviously does not understand why.... And, since you insist.... Yes, you need to create a "host" static route as suggested in the article. No, system-config-network's Route Tab is designed to define remote networks, not host/dev entries, so you are on your own in "defining" it. The file that probably makes the most sense to put the entry in to is /etc/sysconfig/network-scripts/route-eth0 (assuming this is based on eth0). Instead of the article's use of "up", you want to look at the syntax of the "ip" command: ip route add .... Good luck, cause I think you're going to need it.... --Rob -- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
