On Thu, 2008-03-27 at 14:10 +1100, Y Uanlux wrote:
> On Thu, Mar 27, 2008 at 1:57 PM, Patrick O'Callaghan
> <pocallaghan@xxxxxxxxx> wrote:
> > On Thu, 2008-03-27 at 10:19 +1100, Y Uanlux wrote:
> > > On Sat, Mar 22, 2008 at 11:51 PM, Patrick O'Callaghan
> > > <pocallaghan@xxxxxxxxx> wrote:
> > > >
> > > > On Fri, 2008-03-21 at 18:17 -0700, Les wrote:
> > > > > HI, folks,
> > > > > I have been trying everything I can find, but cannot successfully sync
> > > > > my Z22, nor my wife's M500. I have read countless messages, edited the
> > > > > USB rules, achieved getting the /dev/palm entry up, but still cannot
> > > > [...]
> > > >
> > > > > pi_bind error: /dev/pilot Invalid argument
> > > >
> > > > Is it /dev/palm or /dev/pilot?
> > > >
> > > > That aside, you definitely want to get a recent version of pilot-link
> > > > (the underlying package that jpilot, kpilot, gnome-pilot etc. are based
> > > > on) and use libusb instead of the visor kernel module. Also make sure
> > > > visor isn't being loaded ("lsmod|grep visor" as root to check) and set
> > > > up jpilot to use "usb:" as its device rather than /dev/whatever. This is
> > > > both faster and much more reliable.
> > > >
> > >
> > > Can this solution apply to Palm T5?
> >
> > Try it. I use a T|X so my suggestion was not specific to the OP's Z22 or
> > M500.
> >
>
> I set up device at jpilot as usb: and blaclisted visor
>
> when I tried to sync i got these error:
>
> ****************************************
> Syncing on device usb:any
> Press the HotSync button now
> ****************************************
> pi_bind error: usb: No such file or directory
> Check your serial port and settings
> Exiting with status SYNC_ERROR_BIND
> Finished
>
> the system log showed :
>
>
> usb 4-1: new full speed USB device using uhci_hcd and address 11
> usb 4-1: configuration #1 chosen from 1 choice
> usb 4-1: USB disconnect, address 11
> usb 4-1: new full speed USB device using uhci_hcd and address 12
> usb 4-1: configuration #1 chosen from 1 choice
> usb 4-1: USB disconnect, address 12
> usb 4-1: new full speed USB device using uhci_hcd and address 13
> usb 4-1: configuration #1 chosen from 1 choice
> usb 4-1: USB disconnect, address 13
> usb 4-1: new full speed USB device using uhci_hcd and address 14
> usb 4-1: configuration #1 chosen from 1 choice
>
> where to go now?
Do you have libusb installed ("yum install libusb")? Also, you should
have /etc/udev/rules.d/60-libpisock.rules and *not*
have /etc/udev/rules.d/10-visor.rules.
poc
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
