Hello, List
I've mounted 2 identical NICs (realtek rtl 8139c) that FC7 identifies
as eth0 and eth1.
now
ethtool eth0
gives me the following:
Settings for eth0:
Link detected: yes
ethtool eth1 gives me really more instead:
Settings for eth1:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Advertised auto-negotiation: Yes
Speed: 10Mb/s
Duplex: Half
Port: MII
PHYAD: 32
Transceiver: internal
Auto-negotiation: on
Supports Wake-on: pumbg
Wake-on: g
Current message level: 0x00000007 (7)
Link detected: no
I've added added ETHTOOL_OPTS="wol g" both at
/etc/sysconfig/network-scripts/ifcfg-eth1 and ifcfg-eth0
but in this last case something goes wrong.
at
service network restart
I obtain the following error message for eth0:
Bringing up interface eth0: Cannot get current wake-on-lan settings:
Operation not supported
not setting wol
that's strange (remember the 2 NICs are identical...)
Please note that I've the xen virtual network interface bridged to eth0
maybe this is the cause?
please note also that I've correctly implemented WOL settings on my
asus P4B533-E motherboard bios.
thanks a lot in advance for your reply,
fabianope
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
