On Fri, 2008-01-04 at 06:37 -0800, Mick M. wrote: > --- Mike <mike.cloaked@xxxxxxxxx> wrote: > > > Mick M. <off_by_1 <at> yahoo.com> writes: > > > > > My results are EXACTLY the same as yours, word for word. > > > My card is an Edimax EW-7218G. > > > > It is not clear from these posts whether you are using the rt2x00 > > driver > > supported in the F8 kernel or not? > > > > > Hi Mike; > yes it uses the rt2xoo moduke, this is a new clean FC8 install. > Here is some more info: > lspci -v > 01:07.0 Network controller: RaLink RT2561/RT61 802.11g PCI > Subsystem: RaLink Unknown device 2561 > Flags: bus master, slow devsel, latency 32, IRQ 20 > Memory at e7000000 (32-bit, non-prefetchable) [size=32K] > Capabilities: [40] Power Management version 2 > > > iwconfig > wlan0 IEEE 802.11g ESSID:"" > Mode:Managed Channel:0 Access Point: Not-Associated > Tx-Power=0 dBm > Retry min limit:7 RTS thr:off Fragment thr=2352 B > Encryption key:off > Link Quality:0 Signal level:0 Noise level:0 > Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 > Tx excessive retries:0 Invalid misc:0 Missed beacon:0 > > > lsmod | grep rt > rt61pci 24641 0 > rt2x00pci 11201 1 rt61pci > rt2x00lib 20929 2 rt61pci,rt2x00pci > rfkill 9297 1 rt2x00lib > input_polldev 7369 1 rt2x00lib > mac80211 115789 2 rt2x00pci,rt2x00lib > parport_pc 26981 0 > parport 32393 1 parport_pc > gameport 14665 2 ns558 > eeprom_93cx6 6081 1 rt61pci > crc_itu_t 6081 2 rt2x00lib,firewire_core > > > iwlist wlan0 scan > wlan0 Scan completed : > Cell 01 - Address: 00:1D:7E:2F:9A:28 > ESSID:"Fedora" > Mode:Master > Channel:6 > Frequency:2.437 GHz (Channel 6) > Quality=49/100 Signal level=-62 dBm > Encryption key:on > Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s; 18 > Mb/s > 24 Mb/s; 36 Mb/s; 54 Mb/s; 6 Mb/s; 9 Mb/s > 12 Mb/s; 48 Mb/s > Extra:tsf=0000006620119099 > > cat /etc/sysconfig/network-scripts/ifcfg-wlan0 > # RaLink RT2561/RT61 802.11g PCI > DEVICE=wlan0 > BOOTPROTO=dhcp > ONBOOT=yes > HWADDR=00:0e:2e:e5:28:f9 > NETMASK= > DHCP_HOSTNAME= > IPADDR= > DOMAIN= > TYPE=Wireless > USERCTL=yes > IPV6INIT=no > PEERDNS=yes > ESSID=Fedora > CHANNEL=1 > MODE=Managed > RATE=Auto > > I tried to find man or info on wpa_supplicant, no data. > > cat /etc/sysconfig/wpa_supplicant > INTERFACES="" > DRIVERS="" > > I don't know what to put in there. > > > I have previously posted my web page on this forum explaining the > > details > > of the setup. > > > > I searched the archive and found a bunch from you in Dec. > No web page info though. > > Thanks > Mick M. > > Death before Decaf!!! > Have you tried using networkmanager? It will bring up a panel from which to choose WPA options. Of course it helps to know what options you need to use which depends on how the network is using WPA. My method is to try all the options until it works. Rick B. -- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
