On Tue, 2008-01-01 at 13:55 +0100, Timothy Murphy wrote:
> Rick Bilonick wrote:
>
> > If I try to manually configure the nic using iwconfig, I can set the key
> > but I CANNOT get it to set the essid:
> >
> > [root@localhost ~]# iwconfig wlan0 essid default
> > [root@localhost ~]# iwconfig wlan0
> > wlan0 IEEE 802.11g ESSID:off/any
> > Mode:Managed Frequency:2.462 GHz Access Point:
> > Not-Associated
> > Bit Rate:54 Mb/s Tx-Power:25 dBm
> > RTS thr:2347 B Fragment thr:2346 B
> > Encryption key:off
> > Power Management:off
> > Link Quality:0 Signal level:0 Noise level:0
> > Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
> > Tx excessive retries:0 Invalid misc:0 Missed beacon:0
> >
> > (iwconfig will set the key, but I'm not showing the key info.)
> >
> > When I use dhclient to obtain a lease, it tells me no leases were
> > offered (even though the other laptop is connected to the wireless
> > network and I've had them both wirelessly connected at the same time
> > when using Fedora 6 on the Dell).
>
> I'm not a WiFi guru, but it seems to me that if "iwlist scan" works
> there cannot be too much wrong with WiFi on your system.
>
> I would check /etc/dhcpd.conf on the remote system
> to make sure it matches your WiFi device.
> If the MAC is given, is it correct?
> If it is not given, try adding it.
> Could there be some duplication in the file,
> as you have been changing your disk?
> Does "service dhcpd restart" work OK on the remote machine?
>
> Also, is /etc/dhclient-wlan0.conf (or /etc/dhclient.conf)
> on your local machine reasonable?
>
> Are you using NetworkManager (NM)?
> If so, you could try turning it off
> and run system-config-network.
>
> As I said, I am not an expert on WiFi,
> just someone who has had a lot of experience with it, mostly bad ...
>
> --
> Timothy Murphy
> e-mail (<80k only): tim /at/ birdsnest.maths.tcd.ie
> tel: +353-86-2336090, +353-1-2842366
> s-mail: School of Mathematics, Trinity College, Dublin 2, Ireland
>
I removed ndiswrapper and re-installed everything. Still didn't work.
Changed the router to WEP open system (from shared key) (still requires
a key from what I can tell), still didn't work. Took the laptop to work
to try connecting to the wpa network (after re-enabling networkmanager)
- couldn't connect via WPA. Brought it home, turned it on (with an old
D-Link 650 card which I had been using in place of the bcm4318 mini wifi
card) and it connected to a neighbors network (at least I think it was a
neighbors network) but I thought it was through the 650 pcmcia card. But
when I checked, networkmanager clearly showed the available networks for
both wireless cards and it was definitely connected via the 4318 (which
I've been working on for a week). I thought this was too good to be true
- not sure what has changed. I checked to make sure I was actually
connected (using ssh to connect to my Linux machine at work) and was
successful. I disconnected, and clicked my network in networkmanager and
to my utter amazement it connected. Again, not sure what had previously
gone wrong.
[root@localhost ~]# iwconfig wlan0
wlan0 IEEE 802.11g ESSID:"default"
Nickname:"localhost.localdomain"
Mode:Managed Frequency:2.412 GHz Access Point:
00:18:E7:0B:50:B0
Bit Rate=54 Mb/s Tx-Power:25 dBm
RTS thr:2347 B Fragment thr:2346 B
Encryption key:xxxx-xxxx-xx Security mode:open
Power Management:off
Link Quality:70/100 Signal level:-51 dBm Noise level:-96 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
Rick B.
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
