On Wed, 2007-12-19 at 10:10 +1000, david walcroft wrote: > How do I pull this type of message out and place into a directory > [bpalogin] > > Dec 19 09:12:58 reddwarf bpalogin[1965]: Error binding auth socket - Bad > file descriptor > Dec 19 09:12:58 reddwarf bpalogin[1965]: Sleeping for 60 seconds > Dec 19 09:42:59 reddwarf bpalogin[1965]: Auth host = > sm-server.qld.bigpond.net.au:5050 > Dec 19 09:42:59 reddwarf bpalogin[1965]: Listening on port 5050 > > I get a lot of these they fill up 'messages'. I googled it. As far as I can see it can only log to syslog or stdout. I don't see an option to set the priority or the facility for syslogd to treat it differently in the bpalogin config file. If you built it from source, look for the "openlog()" call in the source and you can change the third option to one of "LOCAL_0" through "LOCAL_7" so it uses a different facility, then rebuild it and install the new version. You can then change your /etc/syslog.conf to log to a different spot. For example, if you used LOCAL_5, you could add this to /etc/syslog.conf: # Save bpalogin messages in /usr/local/bpalogin.log local5.* /usr/local/bpalogin.log Run "service syslogd restart" to make syslogd reread its config file, then restart the bpalogin service to run the new version. Any log messages from it should end up in /usr/local/bpalogin.log. ---------------------------------------------------------------------- - Rick Stevens, Principal Engineer rstevens@xxxxxxxxxxxx - - CDN Systems, Internap, Inc. http://www.internap.com - - - - I don't suffer from insanity...I enjoy every minute of it! - ---------------------------------------------------------------------- -- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
