Hello Robert, On Sat, 08 Dec 2007 10:28:08 -0500 Robert L Cochran <cochranb@xxxxxxxxxxxxx> wrote: > I also cannot get sound to work on a Dell D420 laptop running Fedora 8 > with this audio and codec: > > 00:1b.0 Audio device: Intel Corporation 82801G (ICH7 Family) High > Definition Audio Controller (rev 01) > Subsystem: Dell Unknown device 01d6 > Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- > ParErr- Stepping- SERR+ FastB2B- > Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- > <TAbort- <MAbort- >SERR- <PERR- > Latency: 0, Cache Line Size: 64 bytes > Interrupt: pin A routed to IRQ 21 > Region 0: Memory at efebc000 (64-bit, non-prefetchable) [size=16K] > Capabilities: [50] Power Management version 2 > Flags: PMEClk- DSI- D1- D2- AuxCurrent=55mA > PME(D0+,D1-,D2-,D3hot+,D3cold+) > Status: D0 PME-Enable- DSel=0 DScale=0 PME- > Capabilities: [60] Message Signalled Interrupts: Mask- 64bit+ > Queue=0/0 Enable- > Address: 0000000000000000 Data: 0000 > Capabilities: [70] Express Unknown type IRQ 0 > Device: Supported: MaxPayload 128 bytes, PhantFunc 0, > ExtTag- > Device: Latency L0s <64ns, L1 <1us > Device: Errors: Correctable- Non-Fatal- Fatal- Unsupported- > Device: RlxdOrd- ExtTag- PhantFunc- AuxPwr- NoSnoop+ > Device: MaxPayload 128 bytes, MaxReadReq 128 bytes > Link: Supported Speed unknown, Width x0, ASPM unknown, > Port 0 > Link: Latency L0s <64ns, L1 <1us > Link: ASPM Disabled CommClk- ExtSynch- > Link: Speed unknown, Width x0 > > > > Here is the codec: > > [rlc@eng3 ~]$ cat /proc/asound/card0/codec#* | egrep 'Codec' > Codec: SigmaTel STAC9200 > Codec: Conexant ID 2bfa > > Skype test calls refuse on an error message, "unable to capture audio". > This happens even when following the pulseaudio.org suggestions for > running Skype using pasuspender. Did you try disabling pulseaudio-alsa? This becomes quite a common topic here. After I've installed Fedora 8 on my D810 (SigmaTel STAC9750 codec), sound was working, after next reboot it was not. Following some advice found here, I did `yum remove pulseaudio-alsa` then made sure my audio app were using alsa. Works. Regards, -- wwp
Attachment:
signature.asc
Description: PGP signature
-- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
