On Thu, 2007-11-29 at 01:12 +0100, fooboo wrote:
> GAH! I got so close. I had it working for a minute or two. I haven't changed anything since so I've not idea why it stopped again but I could ping the router and not lose packets. "Access point:" had a number there rather than "Not-Associated" but it's gone back to not working.
>
> If anyone has a clue why it would connect then drop the connection a few minutes later I could do with some ideas.
Get it working again and look at the output of iwconfig. Check the
"Link Quality", "Signal level" and "Noise level" values. It could be
that you're on the fringe of your signal area and lost the connection.
Here's output for a solid system:
wlan0 IEEE 802.11g ESSID:"ohnoyoudont"
Mode:Managed Frequency:2.442 GHz Access Point:
xx:xx:xx:xx:xx:xx
Bit Rate=54 Mb/s Tx-Power=27 dBm
Retry min limit:7 RTS thr:off Fragment thr=2346 B
Encryption key:xxxx-xxxx-xxxx-xxxx-xxxx-xxxx-xx
Link Quality=100/100 Signal level=-47 dBm Noise level=-93
dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
That's on a mac80211/iwl4965-based Intel wireless NIC on F7.
----------------------------------------------------------------------
- Rick Stevens, Principal Engineer rstevens@xxxxxxxxxxxx -
- CDN Systems, Internap, Inc. http://www.internap.com -
- -
- Batteries not included. Offer not valid in some states. -
- Your mileage may vary. Void where prohibited. -
----------------------------------------------------------------------
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
