I have a software I like to use called gmfsk which uses the serial
port to turn on and off the transmitter in my radio. It worked fine on
my old computer. Now when I try to run gmfsk it puts up an error panel
that says "Not a serial or parallel port". This made me think the new
computer which has a serial port that is not working.
With a volt meter I find some pins have a constant -10.7 volts on
them which is the standard RS-232 for a no-data signal. In this static
measure the voltmeter sees no positive volts near +12 volts.
Wanting a way to test the serial port I recalled minicom and after
getting it set up on /dev/ttyS0 it seems happy with Com 1. The old
/dev/modem is gone on F7. But now what is a way to drive the serial port
pins to a constant plus voltage with minicom?
I have a scope that I can use if there are no way to make a constant
positive voltage. My fear is that the serial port is broken and can't
make a positive voltage.
--
Karl F. Larsen, AKA K5DI
Linux User
#450462 http://counter.li.org.
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
