On 10/22/07, Michael Schwendt <mschwendt@xxxxxxxxx> wrote: > > Inside the grub prompt, I > > run, as suggested, the command 'find /grub/grub.conf' and I get > > (h0,1). Then I run > > > > configfile /grub/grub.conf > > > > and I get the correct dialog panel to choose the kernel to boot, and > > it goes though until a kernel panic emerges. My grub.conf file is now: > > > > # more /mnt/sdc2/grub/grub.conf > > default=0 > > timeout=5 > > splashimage=(hd0,1)/grub/splash.xpm.gz > > hiddenmenu > > title Fedora (2.6.22.9-91.fc7) > > root (hd2,1) > > kernel /vmlinuz-2.6.22.9-91.fc7 ro root=/dev/sdc2 rhgb > > initrd /initrd-2.6.22.9-91.fc7.img > > title Fedora (2.6.22.7-85.fc7) > > root (hd2,1) > > kernel /vmlinuz-2.6.22.7-85.fc7 ro root=/dev/sdc2 rhgb > > initrd /initrd-2.6.22.7-85.fc7.img > > > > where should I insert > > > > map (hd0) (hd2) > > map (hd2) (hd0) > > after each of the "title" lines. > > > and what should I do to avoid the kernel panic? I suspect that > > something is wrong with 'root=/dev/sdc2'. > > This root= is a Linux kernel parameter and must point to your system's > root partition, which is LVM (on sdc3). It is not sdc2, which is only > your /boot partition. With replacing kernel /vmlinuz-2.6.22.9-91.fc7 ro root=/dev/sdc2 rhgb with kernel /vmlinuz-2.6.22.9-91.fc7 ro root=/dev/sda1 rhgb I could boot in /dev/sda1 where there is a copy of /dev/sdc3. I would prefer to use /dev/sda for F7 instead of using /dev/sdc, as /dev/sda is much larger. If I make a copy of the partition /dev/sdc2 in a partition inside /dev/sda, should I expect F7 working fine fully on /dev/sda? If so, where should I configure that the two partitions in /dev/sda are two logical volumes? Paul -- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
