On 20/09/2007, Jesus Jr M Salvo <jesus.m.salvo@xxxxxxxxx> wrote: > On 20/09/2007, Martin Marques <martin@xxxxxxxxxxxxxxx> wrote: > > Jesus Jr M Salvo wrote: > > > Where did you get the latest bcm43xx-fwcutter ? AFAIK, the one with F7 > > > has not been updated since F7 was released. > > > > http://mirrors.kernel.org/fedora/updates/7/i386/b43-fwcutter-008-1.fc7.i386.rpm > > > > It's got a new name. > > > > -- > > > Thanks ... However, it seems that this only supports a limited amount > of drivers: > > # b43-fwcutter --list > b43-fwcutter version 008 > > Extracting firmware is possible from these binary driver files: > > <driver> <filename> <microcode> <MD5 checksum> > > b43legacy wl_apsta.o 295.14 > e08665c5c5b66beb9c3b2dd54aa80cb3 > b43 wl_apsta.o 351.126 > 9207bc565c2fc9fa1591f6c7911d3fc0 > b43 wl_apsta_mimo.o 351.126 > 722e2e0d8cc04b8f118bb5afe6829ff9 > b43 wl_ap.o 410.2160 > 1e4763b4cb8cfbaae43e5c6d3d6b2ae7 > > > Unlike bcm43xx-fwcutter which supported quite a lot. > > And where does one obtain wl_ap.o ? The tar > http://downloads.openwrt.org/sources/broadcom-wl-4.80.53.0.tar.bz2 > only contains wl_apsta.o > > Regards, > John > I have just tried the new kernel .... The new kernel is unstable for me. It hangs very quickly. Most often, it hangs when starting up wpa_supplicant and gives the following stack trace: Sep 20 21:40:36 c211-30-70-23 kernel: Call Trace: Sep 20 21:40:36 c211-30-70-23 kernel: [<ffffffff8824e159>] :b43:b43_lo_g_adjust_to+0x66/0x71 Sep 20 21:40:36 c211-30-70-23 kernel: [<ffffffff8824e646>] :b43:lo_measure_restore+0xd4/0x360 Sep 20 21:40:36 c211-30-70-23 kernel: [<ffffffff8824f90b>] :b43:b43_lo_g_measure+0x1039/0x1078 Sep 20 21:40:36 c211-30-70-23 kernel: [<ffffffff8824b7da>] :b43:b43_phy_initg+0xad2/0xd10 Sep 20 21:40:36 c211-30-70-23 kernel: [<ffffffff8824c1c6>] :b43:b43_phy_init+0x582/0x5a7 Sep 20 21:40:36 c211-30-70-23 kernel: [<ffffffff8823ff3a>] :b43:b43_chip_init+0x69e/0x9b5 Sep 20 21:40:36 c211-30-70-23 kernel: [<ffffffff882404ef>] :b43:b43_wireless_core_init+0x29e/0x7bb Sep 20 21:40:36 c211-30-70-23 kernel: [<ffffffff8824155a>] :b43:b43_add_interface+0x5f/0xf4 Sep 20 21:40:36 c211-30-70-23 kernel: [<ffffffff8819a7ca>] :mac80211:ieee80211_open+0x23f/0x370 Sep 20 21:40:36 c211-30-70-23 kernel: [<ffffffff812446f9>] wext_handle_ioctl+0x354/0x39d Sep 20 21:40:36 c211-30-70-23 kernel: [<ffffffff811e05d1>] dev_open+0x2f/0x6e Sep 20 21:40:36 c211-30-70-23 kernel: [<ffffffff811de799>] dev_change_flags+0x5a/0x118 Sep 20 21:40:36 c211-30-70-23 kernel: [<ffffffff8122299f>] devinet_ioctl+0x235/0x597 Sep 20 21:40:36 c211-30-70-23 kernel: [<ffffffff8124bf6e>] do_page_fault+0x476/0x7b4 Sep 20 21:40:36 c211-30-70-23 kernel: [<ffffffff811d40f7>] sock_ioctl+0x1c8/0x1e5 Sep 20 21:40:36 c211-30-70-23 kernel: [<ffffffff8109f8f7>] do_ioctl+0x2b/0xb6 Sep 20 21:40:36 c211-30-70-23 kernel: [<ffffffff8109fbc5>] vfs_ioctl+0x243/0x25c Sep 20 21:40:36 c211-30-70-23 kernel: [<ffffffff8109fc37>] sys_ioctl+0x59/0x7a Sep 20 21:40:36 c211-30-70-23 kernel: [<ffffffff81009cd5>] tracesys+0xd5/0xda Sep 20 21:40:36 c211-30-70-23 kernel: Sep 20 21:40:36 c211-30-70-23 kernel: b43-phy0 ERROR: Adjusting Local Oscillator to an uncalibrated control pair: rfatt=3,no-padmix bbat t=0 Sep 20 21:40:36 c211-30-70-23 kernel: b43-phy0 ERROR: bbatt(11) >= size of LO array Sep 20 21:40:36 c211-30-70-23 kernel: b43-phy0 ERROR: Adjusting Local Oscillator to an uncalibrated control pair: rfatt=3,no-padmix bbat t=0 Sep 20 21:40:36 c211-30-70-23 kernel: b43-phy0 ERROR: Adjusting Local Oscillator to an uncalibrated control pair: rfatt=3,no-padmix bbat This was using the existing firmware that I had ( from the latest broadcomm winxp driver from HP's website for my specific model of notebook ). This firmware never caused a crash on the previous kernel ... so why would it cause one now ? Regards, John -- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list