On Sat, 14 Jul 2007 13:39:29 -0600, Karl Larsen wrote:
[...]
> Well nm-tool is accurate. You have it all set up but it isn't working.
> Check /etc/modprobe.conf and remove anything you put in it. I think you
> put a wlan0 in there.
>
> Karl
[root@mbrc35 ~]# cat /etc/modprobe.conf
alias eth0 e100
alias scsi_hostadapter ata_piix
alias snd-card-0 snd-hda-intel
options snd-card-0 index=0
options snd-hda-intel index=0
alias wlan0 3c501
I did not add the last line, but I changed eth1 to wlan0.
In any case, I commented it out and rebooted. When I tried
to activate, I still got:
Error for wireless request "Set Mode" (8B06) :
SET failed on device wlan0 ; Device or resource busy.
Error for wireless request "Set Bit Rate" (8B20) :
SET failed on device wlan0 ; Operation not supported.
Determining IP information for wlan0... failed.
I am thinking of reinstalling FC7. I may have messed up
something in fiddling around. In any case, I have to stop
working on this now. I'll get back to it later this evening
or tomorrow.
Mike.
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
