Hi all,
I 'm just install a scsi card BusLogic BT-958 and HP DAT 40, on my
fedora core 6 system. I usually backup my system, using tar.
My problem is backup doesn't running well.
And this is my backup script:
#tar -b 1024 -cvf /dev/st0 /usr/local/src/my_home/yahoomail | bzip2 -9 >
/var/log/Backup.log.bz2
Backup only run a while, and archive some files in directory and then stop.
[root@mis-s155 ~]# tar -b 1024 -cvf /dev/st0
/usr/local/src/my_home/yahoomail | bzip2 -9 > /var/tmp/Backup.log.bz2
tar: Removing leading `/' from member names
tar: /dev/st0: Cannot write: Device or resource busy
tar: Error is not recoverable: exiting now
But when I put out -b parameter on tar. It run a while and not backup
directory at all
The backup script I used was running well when I'm using redhat 9.0 system.
I attach some message from my system
scsi: ***** BusLogic SCSI Driver Version 2.1.16 of 18 July 2002 *****
scsi: Copyright 1995-1998 by Leonard N. Zubkoff <lnz@xxxxxxxxxxxxx>
scsi5: Configuring BusLogic Model BT-958 PCI Wide Ultra SCSI Host Adapter
scsi5: Firmware Version: 5.06I, I/O Address: 0xDC00, IRQ Channel:
225/Level
scsi5: PCI Bus: 2, Device: 3, Address: 0xFEAFF000, Host Adapter SCSI ID: 7
scsi5: Parity Checking: Enabled, Extended Translation: Enabled
scsi5: Synchronous Negotiation: Fast, Wide Negotiation: Enabled
scsi5: Disconnect/Reconnect: Enabled, Tagged Queuing: Enabled
scsi5: Scatter/Gather Limit: 128 of 8192 segments, Mailboxes: 211
scsi5: Driver Queue Depth: 211, Host Adapter Queue Depth: 192
scsi5: Tagged Queue Depth: Automatic, Untagged Queue Depth: 3
scsi5: SCSI Bus Termination: Both Enabled, SCAM: Disabled
scsi5: *** BusLogic BT-958 Initialized Successfully ***
scsi5 : BusLogic BT-958
Vendor: HP Model: C5683A Rev: YP61
Type: Sequential-Access ANSI SCSI revision: 03
scsi 5:0:3:0: Attached scsi generic sg1 type 1
st: Version 20050830, fixed bufsize 32768, s/g segs 256
st 5:0:3:0: Attached scsi tape st0
st0: try direct i/o: yes (alignment 512 B)
[root@mis-s155 ~]# mt -f /dev/st0 status
SCSI 2 tape drive:
File number=-1, block number=-1, partition=0.
Tape block size 0 bytes. Density code 0x26 (DDS-4 or QIC-4GB).
Soft error count since last status=0
General status bits on (1010000):
ONLINE IM_REP_EN
I very appeciate for any solution and comment.
Thank you
Budiono
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
