Hello,
I just upgrade fc4 -> fc6 with fc6 unity respin and it worked like a charm! But I got trouble setting up my network.
My setup is (should be):
local network:
eth0 Link encap:Ethernet HWaddr 00:0E:2E:54:9B:D6
inet addr:192.168.0.12 Bcast:192.168.0.255 Mask:255.255.255.0
adsl modem conn:
eth1 Link encap:Ethernet HWaddr 00:02:44:27:BC:7E
inet addr:213.10.28.64 Bcast:213.10.28.64 Mask:255.255.255.255
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
10.0.0.138 213.10.28.64 255.255.255.255 UGH 0 0 0 eth1
192.168.0.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0
0.0.0.0 10.0.0.138 0.0.0.0 UG 0 0 0 eth1
eth1 is a connected to a adsl modem where eth1 gets my public ip address. The adsl gateway address (in the modem) is
10.0.0.138. eth1 is nat router for my local lan (192.168.0.0). Works like a charm but I can't get it work with
initscripts (/etc/sysconfig/netwoking). It did work with fc4 initscripts.
bringing it up by hand:
ifconfig eth0 192.168.0.12 ..
ifconfig eth1 213.10.28.64 ..
route add 192...
route add 10.0.0.138/0 gw 213.10.28.64
route add default gw 10.0.0.138
works ok.
These are my not working initscripts:
ifcfg-eth0:
ONBOOT=yes
USERCTL=no
PEERDNS=no
TYPE=Ethernet
DEVICE=eth0
BOOTPROTO=none
NETMASK=255.255.255.0
IPADDR=192.168.0.12
HWADDR=00:0e:2e:54:9b:d6
ifcfg-eth1:
IPV6INIT=no
ONBOOT=yes
USERCTL=no
PEERDNS=no
TYPE=Ethernet
DEVICE=eth1
BOOTPROTO=none
NETMASK=255.255.255.255
IPADDR=213.10.28.64
GATEWAY=10.0.0.138
#GATEWAYDEV=eth1
HWADDR=00:02:44:27:bc:7e
route-eth1:
GATEWAY0=10.0.0.138
NETMASK0=255.255.255.255
ADDRESS0=10.0.0.138
a network restart gives:
Bringing up loopback interface: [ OK ]
Bringing up interface eth0: [ OK ]
Bringing up interface eth1: RTNETLINK answers: Network is unreachable
[ OK ]
[root@brown ~]# route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.0.0 * 255.255.255.0 U 0 0 0 eth0
The (different) fc4 script is:
route-eth1:
10.0.0.138 dev eth1
default via 10.0.0.138
Anybody who can shine a light on this?
thnx,
Michiel
