Kenneth Wolcott wrote:
Hi;
I deleted the rpm db files.
I then ran yum update again.
Seems to go fine for quite awhile and then...
It sounds like you probably have entries within your rpm database that
are leftovers from the yum blunt exit. You probably need to remove the
/var/lib/rpm/__db* files and run rpm --rebuilddb to get the database in
a usable state. Afterwards, you will have to find the packages which are
multi-versions on your system and clean up the messed up entries for the
files. Hopefully the botched update did not include a lot of packages so
the mess would not be extreme.
The easiest way is to run rpm -qa and sort the output to locate packages
which might show two or more entries. Next you would want to verify the
two packages and find out which one verifies and which one shows
problems. Then you would want to remove only the database entry for the
version that does not come back clean with the --justdb option to rpm.
After the mess is cleaned up you might be able to update the system
successfully again with yum. As you mentioned your system speed and
other options, you might be pressing the edge too much with trying to
use resource hungry programs like yum. I think 333 MHz would work but it
would be extremely slow.
Jim
--
The amount of weight an evangelist carries with the almighty is measured
in billigrahams.
