Hi
I have a USB disk. when I plug in, I always get messenge as follows, Could the "over-current" messenge have negative effect on hardware?
thanks,
Yuandan
hub 1-0:1.0: over-current change on port 1
hub 4-0:1.0: over-current change on port 1
usb 4-1: new high speed USB device using ehci_hcd and address 9
usb 4-1: configuration #1 chosen from 1 choice
scsi2 : SCSI emulation for USB Mass Storage devices
usb-storage: device found at 9
usb-storage: waiting for device to settle before scanning
Vendor: HTS54804 Model: 0M9AT00 Rev: 0811
Type: Direct-Access ANSI SCSI revision: 00
SCSI device sde: 78140160 512-byte hdwr sectors (40008 MB)
sde: test WP failed, assume Write Enabled
sde: assuming drive cache: write through
SCSI device sde: 78140160 512-byte hdwr sectors (40008 MB)
sde: test WP failed, assume Write Enabled
sde: assuming drive cache: write through
sde: sde1
sd 2:0:0:0: Attached scsi disk sde
sd 2:0:0:0: Attached scsi generic sg4 type 0
usb-storage: device scan complete
