On Saturday 06 January 2007 22:58, Paulo Cavalcanti wrote: > > For a moment I thought I had struck gold :-) There is a link to > > http://www.lm-sensors.org/wiki/Configurations > > <http://www.lm-sensors.org/wiki/Configurations> and there, sure enough, > > is a configuration file for Abit KV8Pro. Unfortunately, although I > > replaced the old config file with this, I still get the same (lack of) > > readings. > > > > Nevertheless, this page is worthy of a bookmark, I think. > > Every time you change /etc/sensors.conf > > you have to run (as root) > > sensors -s > > Otherwise, you will not use the new file, until you reboot. > > Another file to look at is: > > /etc/sysconfig/lm_sensors > > which holds the modules to be loaded for your board. > It can be (re)created using (as root), > > /usr/sbin/sensors-detect > > and answering yes to all questions. > Done all that before, Paulo. No joy. > As a final remark, ATrpms has an updated version of the lm_sensors rpm. > It does not hurt to try. OK - today I installed this upgrade. Sensors-detect seemed to find more than previously, but 'sensors' still shows fan1: 0 RPM (min = 0 RPM, div = 128) ALARM (beep) fan2: 0 RPM (min = 0 RPM, div = 128) ALARM (beep) fan3: 0 RPM (min = 0 RPM, div = 128) ALARM (beep) temp1: -1°C (high = -1°C, hyst = -1°C) sensor = diode ALARM (beep) temp2: +0.0°C (high = +0°C, hyst = +0°C) sensor = diode ALARM (beep) temp3: +0.0°C (high = +0°C, hyst = +0°C) sensor = diode ALARM (beep) Anne
Attachment:
pgpIvsyZT0rFC.pgp
Description: PGP signature
