Hi, With a fresh install of FC-6 I am having some trouble with my pcmcia wireless card - a 3com 3CRWE154G72. This card uses the prism54 driver, and I have installed the correct firmware file in /lib/firmware (isl3890). I can get it to work by brute force, but would really like to debug this further, and file a bug report under the correct component - right now I'm not sure where the bug is. Symptoms: 1) Card doesn't activate on boot, even though the prism54 module is loaded. Doing a modprobe -r prism54 followed by a modprobe prism54 starts the card succesfully, and all is well. 2) in system-config-network, when I try to add the card under hardware, after I have selected the card, which is identified as 3com 3c501, I get this error message: Command failed: /sbin/modprobe 3c501 Output: FATAL: Module 3c501 not found. Why is it trying to load a module called 3c501? Obviously that's not correct. Is this a problem with HAL perhaps? I have looked thru the fdi files in /use/share/hal/fdi, but nothing leaps out at me. Despite not being able to add this device under hardware, I can succesfully add a network device using this card in the Devices tab, which functions fine, after I've done the modprobe remove and load in (1) above. I am a bit in the dark about what governs which modules are loaded when a device is recognized - is this a hal problem, or a hotplug problem, or?? Any pointers will be welcome, Jonathan
