I've got a FC5 system that I wish to add a SCSI controller (Adaptec 2940)
and a DLT tape drive.
I installed the card and the tape drive and the scsi contoller via its
onboard setup/diagnostics recognizes the tape drive (scsi ID 6).
from the unix machine I do:
cat /proc/scsi/aic7xxx/0
Adaptec AIC7xxx driver version: 7.0
Adaptec 2940 SCSI adapter
aic7870: Single Channel A, SCSI Id=7, 16/253 SCBs
Allocated SCBs: 4, SG List Length: 128
Serial EEPROM:
0x0218 0
[...]
Target 6 Negotiation Settings
User: 10.000MB/s transfers (10.000MHz, offset 127)
Goal: 10.000MB/s transfers (10.000MHz, offset 15)
Curr: 10.000MB/s transfers (10.000MHz, offset 15)
Channel A Target 6 Lun 0 Settings
Commands Queued 10
Commands Active 1
Command Openings 0
Max Tagged Openings 0
Device Queue Frozen Count 0
cat /proc/scsi/scsi
Attached devices:
Host: scsi0 Channel: 00 Id: 06 Lun: 00
Vendor: Quantum Model: DLT4000 CPQ DRV Rev: D473
Type: Sequential-Access ANSI SCSI revision: 02
When I send any commands to /dev/st0 the application just sits there, a
"mt -f /dev/st0 stat" just hangs
lsmod does not show the "mt" device, should it be there and if so, how do
I load it?
TIA,
Jeff
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
