On Oct 25 fredex did spake thusly:
I think I saw in an earlier post in this thread that you don't even
see text from the BIOS at bootup time. While I don't know anything
about DVI, I'd think that if the monitor/cable/video card were
working right that you SHOULD see such text.
I had a strange issue earlier, using the beta nvidia driver...I'd
installed an acpi module for frequency scaling, failed to install an ntfs
module but left the mount command in /etc/fstab - so the acpi module
insert was tried and failed (no such device) and the mount init command
was [Failed] on account of the bad ntfs line.
What I was seeing was:
initial kernel stuff on boot.
Switch to X gui for interactive boot - which then showed the failed
module insert and mount
Then a black screen with a mouse cursor and nothing more
And switching to a different tty just gives me a completely black screen
I resolved both these issues and got X back
If you're seeing up to the switch to X for interactive startup...maybe
it's a similar issue? If you're seeing nothing whatsoever after the bios
POST, no kernel messages at all, then perhaps it's not ;)
IF you're seeing nothing at all, no POST either, then I'd blame your
GPU...
--
Scott van Looy - email:me@xxxxxxxxxxxxxx | web:www.ethosuk.org.uk
site:www.freakcity.net - the in place for outcasts since 2003
PGP Fingerprint: 7180 5543 C6C4 747B 7E74 802C 7CF9 E526 44D9 D4A7
-------------------------------------------
|/// /// /// /// WIDE LOAD /// /// /// ///|
-------------------------------------------
Don't worry over what other people are thinking about you. They're too
busy worrying over what you are thinking about them.
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
