Perhaps I haven't stand fine. I stand you have an external iface (that
is a wifi interface) and you want to connect to your computer using an
VPN (OpenVPN) and then access to your internal network. Am I right?
If I right, you don't need bridge configuration.
When you configure OpenVPN server, this will add a new iface to your
server, then, you only need to allow routing from your VPN network to
your internal network (allow routing and allowing with iptables the
traffic).
The problem that you will encounter is the netbios broadcast frames that
don't allow you explore de routed networks (internal network), but using
direct acces via IP you will access without problems to your samba
shared (windows shares).
Regards
Roger Grosswiler escribió:
I would like to install openvpn afterwards and gain access via wlan on the
external if to the internal network and use printers, shares etc.
I think i gonna need bridging there(?)
Roger
Think in a bridge as a kind of switch. It works at OSI Level 2 (Ethernet)
not at upper levels (IP).
The IP you assign to bridge must be the IP you need to access to the IP
subnet you need to access from the bridge interface.
The first question is: Do you really need a bridge?
If you don't need to connect networks at Ethernet level, you don't need
it.
Perhaps I don't stand fine your required configuration, but I can't see
that you really need bridges.
Can you explain a bit more your wanted configuration?
Regards
--
Samuel Díaz García
ArcosCom Wireless, S.L.L.
CIF: B11828068
c/ Romero Gago, 19
Arcos de la Frontera
11630 - Cadiz
http://www.arcoscom.com
mailto:samueldg@xxxxxxxxxxxx
msn: samueldg@xxxxxxxxxxxx
Tlfn.: 956 70 13 15
Fax: 956 70 34 83
El Jue, 21 de Septiembre de 2006, 9:03, Roger Grosswiler escribió:
Hello,
I think about bridging the firewall on the next install. Unfortunately,
the same firewall routes to 2 other subnets:
- 1 external
- 1 DMZ
Both have separate IP-Ranges. In fact, with the internal Network, i have
3
Subnets (internal-> eth0, external -> eth1, dmz -> eth2)
I would like to now:
Can i use this combination:
1 bridge eth0->eth1
1 bridge eth0->eth2
and: which ip-adress does the bridge need? is there any ip possible or
which one is to set preferably on the bridge?
Thanks for your replies.
Roger
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
--
Samuel Díaz García
Director Gerente
ArcosCom Wireless, S.L.L.
CIF: B11828068
c/ Romero Gago, 19
Arcos de la Frontera
11630 - Cadiz
http://www.arcoscom.com
mailto:samueldg@xxxxxxxxxxxx
msn: samueldg@xxxxxxxxxxxx
Móvil: 651 93 72 48
Tlfn.: 956 70 13 15
Fax: 956 70 34 83
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
