On 9/6/06, T. Horsnell <tsh@xxxxxxxxxxxxxxxxx> wrote:
>On Wed, 2006-09-06 at 18:23 +0100, T. Horsnell wrote:
>> How can I get an FC5 system to boot without a video adapter?
>> At the moment, I cant even figure out how to tell grub that
>> it has no VGA, let alone Linux. Any ideas anyone?
>>
>> Cheers,
>> Terry
>>
>
>Why does it matter? I usually setup headless machines using a serial
>null cable: (AKA Serial console)
>All you need to do is configure grub [1] (and BIOS?), add serial console
But this is what I cant figure out how to do. How to configure
grub so that it doesnt try to use video?
Terry.
>support to the kernel command line [2] and add a serial console to
>inittab [3].
>
>- Gilboa
>
>[1]
>http://www.tldp.org/HOWTO/Remote-Serial-Console-HOWTO/configure-boot-loader-grub.html
>[2]
>http://www.tldp.org/HOWTO/Remote-Serial-Console-HOWTO/configure-kernel-grub.html
>[3]
>http://www.tldp.org/HOWTO/Remote-Serial-Console-HOWTO/getty-agetty.html
>
>
>--
>fedora-list mailing list
>fedora-list@xxxxxxxxxx
>To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
>
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
Hi Terry!
At the GRUB command the "serial" command:
# From the GRUB manual:
-----------------------------------------
13.2.12 serial
serial ['--unit=unit'] ['--port=port'] ['--speed=speed'] [Command]
['--word=word'] ['--parity=parity'] ['--stop=stop'] ['--device=dev']
Initialize a serial device. unit is a number in the range 0-3
specifying which serial
port to use; default is 0, which corresponds to the port often
called COM1. port is the I/O port where the UART is to be
found; if specified it takes precedence over
unit. speed is the transmission speed; default is 9600. word and
stop are the number of data bits and stop bits. Data bits must be in
the range 5-8 and stop bits must be 1 or 2. Default is 8 data bits
and one stop bit. parity is one of 'no', 'odd', 'even' and defaults
to 'no'. The option '--device' can only be used in the grub shell and
is used to specify the tty device to be used in the host operating
system (see Chapter 15 [Invoking the grub shell], page 55).
The serial port is not used as a communication channel unless the
terminal command is used (see Section 13.2.14 [terminal], page 41).
This command is only available if GRUB is compiled with serial
support. See also
Chapter 7 [Serial terminal], page 23.
-----------------------------------------------------------------------
# The GRUB manual is available at:
http://www.gnu.org/software/grub/manual
# Referenced previously but still a good resource
http://www.tldp.org/HOWTO/Remote-Serial-Console-HOWTO/configure-boot-loader-grub.html
Have Fun!
Tod
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
