I am trying to use the Installation program with FC5 to setup a new system with 2 SATA drives. The motherboard has a 'hardware raid' but after a few years of monkeying with this system and drivers, software raid is the correct way to go. However, I am installing FC5 on new hard drives. The installation finishes, I reboot and the boot loader sometimes isn't found at all, or is found, but doesn't have a kernel to boot? The times that the installer puts a boot loader in without a kernel, I type in the parameters: root(hd0,0) kernel... initrd... and the system boots for the first time and I get through the 'first boot stuff (setting soundcard etc)', then I boot again (if I'm lucky) and the system boots. However, at this point is the real symptom of the problem. The raid never has both drives in each partition. The system is configured to have /boot as /dev/md0 (/dev/sda1 + /dev/sdb1)... / as /dev/md1 (/dev/sda2 + /dev/sdb2)... swap as /dev/md2 (/dev/sda3 + /dev/sdb3) except the system is only using sda in partion md0 and sdb in partion md1 and sda in partion md2. Never are both drives in their assigned partitions. So my first question, I've looked through the mailing list archives back a few months and I see no related issues. Is anyone aware of bugs with the software raid installation in FC5? I guess my second question is a general 'help'? Thank you in advance. -- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
