Mike Cisar wrote: > Hopefully someone can point me in the right direction. Am configuring a new > server for a client with FC5, this server has 3 removable SATA drives > (replacing their existing server with 3 removable IDE drives). In their > original server the primary and secondary master drives (hda and hdc > respectively) were software raid 1 and the primary master (hdb) was used as > a backup device. > > In the new server the first 3 drives will be software raid 1 (2 drives, 1 > spare). The motherboard has 4 SATA connectors, for the sake of this email I > will call the drive attached to the first of those connectors drive 1, etc) > As mentioned in another thread, unfortunately removing one of the drives > causes the kernel to shuffle the drive assignments up (rather than simply > leaving a gap as with IDE). IE. normally I will have sda-sdc... if I remove > the second drive, my goal is to have sda and scd (with sdb missing) instead > of having sda, sdb as is assigned by default. > > I have added the following in 10-local.rules > BUS=="scsi", ID=="0:0:0:0", DRIVER=="sd", NAME="sda%n" > BUS=="scsi", ID=="1:0:0:0", DRIVER=="sd", NAME="sdb%n" > BUS=="scsi", ID=="2:0:0:0", DRIVER=="sd", NAME="sdc%n" > BUS=="scsi", ID=="3:0:0:0", DRIVER=="sd", NAME="sdd%n" > > When booting with only 2 drives (the 2nd removed) the above seems to create > all the correct nodes and standard symlinks for sda and sdc and I can > perform operations against sdc as I would expect. Unfortunately the device > node for sdb is also present, presumably from either the kernel's assignment > or the default rules. > > What can I add to my local rules so that the "stray" sdb node is removed or > not created as the case may be (and likewise for any of the other 3 drives > which might for whatever reason be removed from the machine)? > > Regards, >>>>>> Mike <<<<< > > Two things that may help - if your rules come before the default ones, you can add OPTIONS="last_rule" to your rules to stop the default rules from being checked. But I do not think that will help in this case, because the default rules are matching on different "keys". The other thing you could try is to change the names from sda%n to something like raid%n and then configure the RAID driver to use these names. What I suspect is happening when you remove the second drive is that your rules are creating /dev/sda and /dev/sdc, while the default rules are creating /dev/sdb that is the same hardware as /dev/sdc that you created. If you removed the third drive, then the forth would probably end up as both /dev/sdc and /dev/sdd. Mikkel -- Do not meddle in the affairs of dragons, for thou art crunchy and taste good with Ketchup! -- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
