I'm attempting to install a FC5 system using an Adaptec 29320A-R card (I
am not using the worthless Host-raid).
I noticed upon boot I get the following message:
SCSI subsystem initialized
scsi0 : Adaptec AIC79XX PCI-X SCSI HBA DRIVER, Rev 3.0
<Adaptec 29320A Ultra320 SCSI adapter>
aic7901: Ultra320 Wide Channel A, SCSI Id=7, PCI 33 or 66Mhz,
512 SCBs
Vendor: SEAGATE Model: ST373405LC Rev: 0003
Type: Direct-Access ANSI SCSI revision: 03
target0:0:0: asynchronous
scsi0:A:0:0: Tagged Queuing enabled. Depth 4
target0:0:0: Beginning Domain Validation
target0:0:0: wide asynchronous
target0:0:0: FAST-80 WIDE SCSI 160.0 MB/s DT (12.5 ns, offset 63)
target0:0:0: Ending Domain Validation
SCSI device sda: 143374741 512-byte hdwr sectors (73408 MB)
sda: Write Protect is off
sda: Mode Sense: a3 00 10 08
SCSI device sda: drive cache: write back w/ FUA
SCSI device sda: 143374741 512-byte hdwr sectors (73408 MB)
sda: Write Protect is off
sda: Mode Sense: a3 00 10 08
SCSI device sda: drive cache: write back w/ FUA
sda: sda1 sda2 sda3 sda4 < sda5 sda6 sda7 >
sd 0:0:0:0: Attached scsi disk sda
Notice that target 0:0:0 is asynchronous, how do I get that to be
synchronous??
Thanks..
Jeff
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
