Chong Yu Meng wrote:
On Fri, 2006-07-28 at 13:30 +0800, Ketut Mahaindra wrote:
Hello,
You may try to follow some Apache configuration and test page creation
as mentioned in:
http://stanton-finley.net/fedora_core_5_installation_notes.html
See the section on Perl almost at the bottom section of the page.
Best regards
Ito
Ahh! Thanks Ito!
Actually, I tried the instructions there, but for some reason, I can
only display the perl source code instead of the results when I open the
script in a browser using http://servername/printenv.pl
Am I missing some configuration parameter? From the website it appears
that the script should "just work".
When I do "httpd -l" I get the following:
[root@aeonflux conf]# httpd -l
Compiled in modules:
core.c
prefork.c
http_core.c
mod_so.c
So, I don't see mod_perl, but that could be irrelevant. Do I need to
have httpd-devel installed as well?
Hello,
mod_perl is not compiled in, it is a dynamically loadable module, you
may check it if you run <?php phpinfo(); ?> under the "apache2handler"
section - it should be listed under "loaded modules".
As for your problem where the source code was not executed and get
displayed plainly, have you uncomment the line "#AddHandler cgi-script
.cgi" and add ".pl" so that it reads "AddHandler cgi-script .cgi .pl"
inside the /etc/httpd/conf/httpd.conf file ?
Best regards
Ito
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
