Hi, on a up to date FC5 host, with 3 network card, if I load the eth2 first of eth1 or eth0 the network interface eth2 is not created: > [root@cambiami ~]# service network stop > Arresto dell'interfaccia di loopback: [ OK ] > [root@cambiami ~]# grep eth /etc/modprobe.conf > alias eth0 r8169 > alias eth1 natsemi > alias eth2 natsemi > [root@cambiami ~]# rmmod r8169 natsemi > [root@cambiami ~]# rmmod r8169 natsemi > ERROR: Module r8169 does not exist in /proc/modules > ERROR: Module natsemi does not exist in /proc/modules > [root@cambiami ~]# ip a > 1: lo: <LOOPBACK> mtu 16436 qdisc noqueue > link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00 > 5: sit0: <NOARP> mtu 1480 qdisc noop > link/sit 0.0.0.0 brd 0.0.0.0 > [root@cambiami ~]# modprobe -v eth2 > insmod /lib/modules/2.6.17-1.2157_FC5/kernel/drivers/net/natsemi.ko > [root@cambiami ~]# lsmod |grep -E '(r8169|natsemi)' > natsemi 28193 0 > [root@cambiami ~]# ip a > 1: lo: <LOOPBACK> mtu 16436 qdisc noqueue > link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00 > 5: sit0: <NOARP> mtu 1480 qdisc noop > link/sit 0.0.0.0 brd 0.0.0.0 > 18: eth0: <BROADCAST,MULTICAST> mtu 1500 qdisc noop qlen 1000 > link/ether 00:09:5b:1c:9d:97 brd ff:ff:ff:ff:ff:ff > 19: eth1: <BROADCAST,MULTICAST> mtu 1500 qdisc noop qlen 1000 > link/ether 00:40:f4:5f:8e:d1 brd ff:ff:ff:ff:ff:ff > [root@cambiami ~]# In this example, the only network card connect to the network is the eth0 (r8169), eth1 and eth2 there are not connect to the network. How to I can resolve this issue? I must load the interface in the order that I want. With previous FC version this was possible. Many thanks for your suggestions! -- Dario Lesca <d.lesca@xxxxxxxxxx> -- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
