I need to configure the modem part of a pcmcia multifunction ethernet/modem card for my laptop. FC5 appears to correctly identify most parameters but incorrectly identifies the modem part as an ethernet device, eth1. Here are the relevant parts of /etc/sysconfig/hwconf: - class: NETWORK bus: PCMCIA detached: 0 device: eth1 driver: serial_cs desc: "3Com Corporation 3C562D/3C563D EtherLink III LAN+Modem PC Card" vendorId: 0101 deviceId: 0562 function: 1 slot: 1 - - class: NETWORK bus: PCMCIA detached: 0 device: eth2 driver: 3c589_cs desc: "3Com Corporation 3C562D/3C563D EtherLink III LAN+Modem PC Card" network.hwaddr: 00:60:97:ee:c6:fb vendorId: 0101 deviceId: 0562 function: 0 slot: 1 The system is correctly identifying the driver for the modem side of he card. I may have helped get to this point by adding card "3Com 3c562/3c563 Ethernet/Modem" manfid 0x0101, 0x0562 bind "3c589_cs" to 0, "serial_cs" to 1 to /etc/pcmcia/config.opts as indicated in the material at pcmcia-cs.sourceforge.net. The problem is that the device eth1 on the modem side of the card appears to be interfering with my ability to configure the ppp connection in the Network Configuration tool. The tool tells me there are no modems available and does not let me correct the eth1 to something like ppp0, which is what it should be. I tried to edit /etc/sysconfig/hwconf but it appears to be automatically generated at boot time. How do I get FC5 to correctly identify the dialup modem part of the card? Stan Klein -- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
