On Fri, Jun 30, 2006 at 09:20:57AM -0500, Don Maxwell wrote: > On 6/30/06, Randy Wyatt <rwwyatt01@xxxxxxxxx> wrote: > > > >Will you be changing the CPU? and do you use the generic kernel as > >provided by redhat? > >I have brought up redhat after a moterboard and CPU change just fine. > >It only required a little modification. You will have to reconfigure > >X after the system comes up so you may want to make sure that you > >boot into runlevel 3. > > > Yes, the CPU will change but the good news is that I use the generic > kernel from FC5. No recompiles on this system. It will work, almost certainly. Maybe you won't have the most optimal system after the replacement (eg running a i586 kernel on a i686, or no smp kernel (multiprocessor, also used dor hyperthreading and dual core cpus). > Reconfiguring X does concern me a bit. It has been 5 yrs since I last > fiddled with such things. I am afraid that all the advances in Linux > installs with X configs that actually work has left me spoiled and > lazy! :-) Not very hard, run system-config-display , which is essentially the same utility that is used during fedora's installation. If it doesn't run at all, remove /etc/X11/xorg.conf and rerun system-config-display. > > Very good point about booting into runlevel 3! > > Thanks! One thing that caused me problems in a similar situation was when the old system had an onboard network controller, as well as a pci network card, and the new hardware had just one network card. The boot sequence was hanging forever trying to initialize the non-existent eth1. But that was of course easy enough to fix from runlevel 1. David Jansen -- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
