Kam Leo wrote:
On 6/18/06, Peter Horst <phorst@xxxxxxxxxxxxx> wrote:
Boy, I am having such a hard time figuring out what's wrong here. I had
a couple of old beater computers, tried to install fc-5 from a cd set.
Hash-verified, should have been decent disks, etc. No dice. Neither
computer would "see" the boot disk. Thought, "oh, well." Needed a new
box anyway. Picked up an emachines t-3418 yesterday. Burned fc-5 iso
disk 1 onto a new Taiyo Yuden 700mb disk - verified that the data is
present & accounted for (SHA-1 hash matches). And still! Despite any
changes I make to the BIOS settings, I cannot get this computer to boot
from the install disk - tried booting from boot.iso, from the recovery
disk, nothing. Obviously the common denominator here is me, but I can't
figure out what I might be doing wrong. Can a disk checkout hash-wise
and still be bad? What am I missing here? Could it be the windows
software I am using to burn with?
Any help greatly appreciated.
Peter
If you are using CD-RW media use 1X-4X rated media only. 4X-12X media
may work. 12X and higher speed RW media are not most likely not
compatible with older CD-ROM or DVD-ROM drives.
If using a DVD-ROM drive switch to DVD+R or the slow 1X-4X CD-RW
media. Also regardless of media type burn at a lower speed or half of
the maximum rated media speed.
I had this same problem with not being able to boot off the CD even
though it was setup properly in the bios. It turned out that I was
using CD-RW media instead of plain old CD-R media. Once I switched to
the CD-R media everything was fine. Do not know why this would make a
difference but for me it did. Good luck
Peter
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list