Thanks, Laura. CM3218X is under light sensors, and should be a module. The line first gets removed when I run 'make oldconfig,' so I skipped 'make oldconfig.' I still get the same error and it seems to be introduced in the line 'mv kernel-4.4.0-aarch64.config .config' under 'for i in *.config' in the spec file. I've built kernels before, but in this case I want to wind up with a Fedora kernel package I can install and remove cleanly, otherwise I wouldn't be trying to use rpmbuild. I want an i686 kernel... does my command line look correct? rpmbuild -bb --with baseonly --without debuginfo --target=i686 kernel.spec Thanks again, Mike On Mon, Jan 25, 2016 at 11:39 AM, Laura Abbott <labbott@xxxxxxxxxx> wrote: > On 01/23/2016 04:57 PM, Michael Hill wrote: >> >> Since the last version of Fedlet came out, I've been building a kernel >> package on my Baytrail tablet from the fc24 source rpm following these >> instructions: >> >> https://fedoraproject.org/wiki/Building_a_custom_kernel >> >> This worked for a number of 4.2 kernels as well as a couple of 4.4 rc >> kernels. On or about rc6 and continuing with 4.4.0-1, I've been >> running this step: >> >> rpmbuild -bb --with baseonly --without debuginfo --target=i686 kernel.spec >> >> >> ...and (after the patches are applied), failing like this: >> >> Applying: i2c: designware: Convert to use unified device property API >> Applying: drm/udl: Use unlocked gem unreferencing >> + chmod +x scripts/checkpatch.pl >> + touch .scmversion >> + mkdir configs >> + for i in '*.config' >> + mv kernel-4.4.0-aarch64.config .config >> ++ head -1 .config >> ++ cut -b 3- >> + Arch=arm64 >> + grep -E '^CONFIG_' >> + make ARCH=arm64 listnewconfig >> + '[' -s .newoptions ']' >> + cat .newoptions >> CONFIG_CM3218X >> + exit 1 >> error: Bad exit status from /var/tmp/rpm-tmp.niuQ3f (%prep) >> >> >> RPM build errors: >> Bad exit status from /var/tmp/rpm-tmp.niuQ3f (%prep) >> >> >> >> a. Is there something obvious I can fix? >> >> b. Is there a better place to ask? >> > > That (cryptic) error is indicating that CONFIG_CM3218X needs to be set in a > config > file somewhere. Try adding CONFIG_CM3218X=<whatever> to config-local and > build again. You will need to figure out whether <whatever> should be y, n > or m > > Laura _______________________________________________ kernel mailing list kernel@xxxxxxxxxxxxxxxxxxxxxxx http://lists.fedoraproject.org/admin/lists/kernel@xxxxxxxxxxxxxxxxxxxxxxx
