On Mon, 2014-03-17 at 21:42 +0800, Ed Greshko wrote: > On 03/17/14 21:34, Patrick O'Callaghan wrote: > > On Mon, Mar 17, 2014 at 1:24 PM, Ed Greshko <ed.greshko@xxxxxxxxxxx> wrote: > >> I just dragged a 4GB file in Dolphin to my NFS Mounted NAS. A little circle popped into the systray area and clicking on it brings up a "Copying" box with information about how much has been copied and what the current transfer rate is. This goes along for a few minutes and then finally a popup comes from dolphin indicating the transfer is complete. > > That's what I'm talking about. If the circle widget has a name I don't > > know it. My point is that the transfer rate is showing (say) > > 1.6GiB/sec (i.e. gigabytes) which is ridiculous. And of course the > > transfer finishes immediately, which of course it would at that speed. > > It's really not very helpful. > > OK. I'm not seeing that. I'm seeing a reasonable transfer rate and it doesn't show "completed" until it actually is and the popup from Dolphin shows up. Also have a 1000Mbps LAN. As I say, it doesn't show completed until it actually completes, but in the meantime the information it shows is meaningless. As a test, I copied the same file in both directions. Copying to the NAS behaves as I described. Copying from the NAS shows a believable transfer rate and estimated completion time. In both cases the real completion time was the same. I have screenshots of both transfers, and once I figure out how to upload then to fedorapeople.org I'll post them there. See _______________________________________________ kde mailing list kde@xxxxxxxxxxxxxxxxxxxxxxx https://admin.fedoraproject.org/mailman/listinfo/kde New to KDE4? - get help from http://userbase.kde.org
