On Friday, 23 April 2021 at 15:49, Dennis Gilmore wrote: > On Fri, Apr 23, 2021 at 7:14 AM Dominik 'Rathann' Mierzejewski > <dominik@xxxxxxxxxxxxxx> wrote: > > > > On Thursday, 22 April 2021 at 18:07, Paul Whalen wrote: > > > > > > Hi Everyone, > > > > > > Please help to test the Fedora 34 RC on your favourite ARM or AArch64 > > > device, and add your results to the Fedora Wiki: > > > > > > https://fedoraproject.org/wiki/Test_Results:Fedora_34_RC_1.1_Summary > > > > > > All testing is greatly appreciated! > > > > I'd be happy to test on my Pinebook Pro, but I'd appreciate some > > instructions on how to flash the U-Boot SPI image (idbloader.spi?) > > onto the SPI. Peter pointed me to > > https://marcin.juszkiewicz.com.pl/2020/06/17/ebbr-on-rockpro64/ on IRC, > > but it's for a different board. How can I find out the correct address > > for load and sf update/write commands? > > There is no need to know the memory locations, there are variables > defined for that. On my RockPro64 I ran the following > > sf probe > load mmc 1:1 ${fdt_addr_r} idbloader.spi > sf update ${fdt_addr_r} 0 ${filesize} > load mmc 1:1 ${fdt_addr_r} u-boot.itb > sf update ${fdt_addr_r} 60000 ${filesize} > > reset and it booted off of SPI,I created the sdcard that I booted off > and contained u-boot by running > spi-flashing-disk --media=/dev/sda --target rockpro64-rk3399 > > my desktop has nvme drives so the first USB drive shows up as /dev/sda > > you may need to use mmc info to get the right device or run > ls mmc 0:1 > ls mmc 1:1 > until you see the device that contains the right bits, then set the > correct device to load from Thanks, I actually knew as much. How can I make sure that the ${fdt_addr_r} variable contains the correct address, though? Regards, Dominik -- Fedora https://getfedora.org | RPM Fusion http://rpmfusion.org There should be a science of discontent. People need hard times and oppression to develop psychic muscles. -- from "Collected Sayings of Muad'Dib" by the Princess Irulan _______________________________________________ arm mailing list -- arm@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe send an email to arm-leave@xxxxxxxxxxxxxxxxxxxxxxx Fedora Code of Conduct: https://docs.fedoraproject.org/en-US/project/code-of-conduct/ List Guidelines: https://fedoraproject.org/wiki/Mailing_list_guidelines List Archives: https://lists.fedoraproject.org/archives/list/arm@xxxxxxxxxxxxxxxxxxxxxxx Do not reply to spam on the list, report it: https://pagure.io/fedora-infrastructure