> Just tested with Kernel 5.0.1-300.fc29.armv7hl, same problem, out of 3 reboots one did not manage to initialise network. So one of the patches I referenced above, "usb: dwc3: exynos: Fix error handling of clk_prepare_enable" is in 5.0 and just landed in 4.20.16, the other problem is basically summarised in the following post https://www.spinics.net/lists/linux-usb/msg177861.html But should be mitigatable with "rd.driver.pre=xhci-plat-hcd " > The kernel tried to power cycle the port; > > [ 19.429292] xhci-hcd xhci-hcd.1.auto: Timeout while waiting for setup device command > [ 19.637128] usb 6-1: device not accepting address 2, error -62 > [...] > [ 30.901110] usb 6-1: device not accepting address 3, error -62 > [ 30.927259] usb usb6-port1: attempt power cycle > (full boot logs can be provided if needed, > but that did not bring the device up. > From that state the only way to fix it was a power cycle of the whole ODROID-HC2. > > pcfe > _______________________________________________ > arm mailing list -- arm@xxxxxxxxxxxxxxxxxxxxxxx > To unsubscribe send an email to arm-leave@xxxxxxxxxxxxxxxxxxxxxxx > Fedora Code of Conduct: https://getfedora.org/code-of-conduct.html > List Guidelines: https://fedoraproject.org/wiki/Mailing_list_guidelines > List Archives: https://lists.fedoraproject.org/archives/list/arm@xxxxxxxxxxxxxxxxxxxxxxx _______________________________________________ arm mailing list -- arm@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe send an email to arm-leave@xxxxxxxxxxxxxxxxxxxxxxx Fedora Code of Conduct: https://getfedora.org/code-of-conduct.html List Guidelines: https://fedoraproject.org/wiki/Mailing_list_guidelines List Archives: https://lists.fedoraproject.org/archives/list/arm@xxxxxxxxxxxxxxxxxxxxxxx
