Re: what do i have to do to enable spi on fedora 27 on a raspberry pi

[adpdyj+4aw13di0ccx1w@xxxxxxxxxxxxxxx]

for the sake of completeness: 

diff --git a/arch/arm/boot/dts/bcm283x.dtsi b/arch/arm/boot/dts/bcm283x.dtsi
index 9d293decf8d3..d32d4861c98d 100644
--- a/arch/arm/boot/dts/bcm283x.dtsi
+++ b/arch/arm/boot/dts/bcm283x.dtsi
@@ -26,2 +26,3 @@
 		serial1 = &uart1;
+		ethernet1 = &eth1;
 	};
@@ -375,2 +377,15 @@
 			};
+			spi0_pins: spi0_pins {
+				brcm,pins = <9 10 11>;
+				brcm,function = <BCM2835_FSEL_ALT0>;
+			};
+			spi0_cs_pins: spi0_cs_pins {
+				brcm,pins = <8 7>;
+				brcm,function = <BCM2835_FSEL_GPIO_OUT>;
+			};
+			eth1_pins: eth1_pins {
+				brcm,pins = <25>;
+				brcm,function = <BCM2835_FSEL_GPIO_IN>;
+				brcm,pull = <BCM2835_PUD_OFF>;
+			};
 		};
@@ -415,3 +430,17 @@
 			#size-cells = <0>;
-			status = "disabled";
+			status = "okay";
+			dmas = <&dma 6>, <&dma 7>;
+			dma-names = "tx", "rx";
+			pinctrl-names = "default";
+			pinctrl-0 = <&spi0_pins &spi0_cs_pins>;
+			cs-gpios = <&gpio 8 GPIO_ACTIVE_LOW>, <&gpio 7 GPIO_ACTIVE_LOW>;
+			eth1: enc28j60@0 {
+				compatible = "microchip,enc28j60";
+				reg = <0>;
+				pinctrl-names = "default";
+				pinctrl-0 = <&eth1_pins>;
+				interrupt-parent = <&gpio>;
+				interrupts = <25 IRQ_TYPE_EDGE_FALLING>;
+				spi-max-frequency = <24000000>;
+			};
 		};

$CPP -I../../../../include -E -P -x assembler-with-cpp bcm2837-rpi-3-b.dts | dtc -I dts -O dtb -o bcm2837-rpi-3-b.dtb -
_______________________________________________
arm mailing list -- arm@xxxxxxxxxxxxxxxxxxxxxxx
To unsubscribe send an email to arm-leave@xxxxxxxxxxxxxxxxxxxxxxx